IDE to SATA Bi-Directional Convertor - No Driver Needed

0 Review(s)

  • Item#: CVSB-802
  • Retail price:   US$9.18
  • Wholesale Price: US$5.92

  • Minimum Order: 1 Piece(S)

  •  Sold Out 

    IDE to SATA Bi-Directional Convertor
    Are you stuck with a new motherboard and some old hard disk drives? Want to get some of the data off those old drives but finding the connectors just don't match up? A bidirectional IDE to SATA converter could be just what you need, for using SATA drives on an older IDE based motherboard, or IDE drives on a newer SATA based motherboard.

    The unit features support for the maximum IDE data rate or 150 MB/S, simple installation and compact design to take up minimal room inside your case. A simple, effective and valuable item to be had in any geeks arsenal, brought to you at a great factory-direct wholesale price and in stock in our warehouse, able to be shipped direct to you or your customers door today!

    Manufacturer Specification

    • Supported Transfer Rates: 16.7, 25, 33, 48, 66, 100, 133, 150 MB/S
    • Power Source: 5V DC + 12V DC from Molex PC Power Connector (from Power Supply Unit of Computer)
    • Dimensions: 50mm x 4 x 47mm (L x W x D)
    • Wholesale Electronics Ref.: WholesaleEAGTK5JWTKA6

    Notes from Manufacturers

    • Power LED
    • No Drivers Needed
    • SATA 1.0 Compliant
    • Automatic SATA 1.5Gbps Speed Negotiation (You don't have to turn down the speed of the other drives on the same SATA controller)
    • Support SATA hot plug swapping
    • Simple Switch and Jumper Setting for IDE to SATA or SATA to IDE setting
    • Support for Partial and Full Sleep Power Management (Dependent on the Drive/ Operating System/ and Motherboard in use)
    • Support for Slave mode
    • Ultra Low Power Consumption

    Package List for CVSB-802

    • IDE to SATA Bi-Directional Convertor Card
    • SATA Data Cable
    • Power Supply Cable (Requires 1 Molex Connector from PS Power Supply

    This product was added to our catalog on Friday 18 April, 2008.


        Please refer to the bottom of the site.